Commands

By Default all commands on the NEVARC Linking system start with a *. This can be changed by a node owner as described in Advanced Stuff, however, it should be left as default.

There are several commands that is built in as standard to the node system. These include the ability to reset the node, reboot the node and run some test commands.

Default Command List(Edit)

Every new node image that is downloaded includes the following commands Starting with a * and should end with a #:

1 Disconnect.

2 Monitor.

3 Connect.

4 Run a command.

The echolink driver uses the same first three commands as the VK Link system. The difference, all echolink nodes are padded out to 6 digits with a preceding 3.

For example:

  • To connect to the echolink test server (el node 9999), you would dial: *33009999
  • To disconnect your would dial *13009999

To connect and disconnect to node 123456, you would dial

  • *33123456
  • *13123456

IRLP Commands(Edit)

The IRLP driver uses the same first three commands as the VK Link system. The difference, all IRLP nodes have a preceding 9.

For example:

  • To connect to IRLP node number 1234, you would dial *391234
  • To disconnect from node number 1234, you would dial *191234

Main page

Menu

Article:

Search: